MW4 Best PS5 Settings for DMZ
Last verified · Game build: launch
Turn on 120 Hz output and VRR in the PS5 system settings, then switch on 120Hz in-game. Turn off motion blur, depth of field and film grain, set FidelityFX CAS to around 50–70 and start with an FOV of 105.
Display
PS5 system: 120 Hz Output
Automatic (with VRR on)
Needed before the in-game 120Hz option does anything; VRR smooths dips.
In-game 120Hz
On
Higher frame rate and lower latency on a 120Hz TV or monitor.
Quality
Motion Blur / Depth of Field / Film Grain
Off
Clearer image while moving and aiming.
FidelityFX CAS
50–70
Sharpens the upscaled image without much cost.
View
Field of View
Start at 105
A good starting point on a TV; adjust to taste.
Before you launch the game
In the PS5 system settings, set 120 Hz Output to Automatic and turn on VRR. The in-game 120Hz option only helps if your TV or monitor supports 120Hz.
In-game settings
The table below lists the reported values. We will check the exact PS5 menu names in the full game after launch.
Field of view on console
The console FOV slider goes up to 120, which most players find too zoomed out. Start at 105 and adjust from there.
PS5 Pro
PS5 Pro is reported to use enhanced PSSR upscaling. We will add Pro-specific advice after launch.
FAQ
Can MW4 DMZ run at 120Hz on PS5?
Reported yes, with 120 Hz output enabled in the PS5 system settings, the in-game 120Hz option turned on and a display that supports 120Hz.
What is the best FOV for DMZ on PS5?
Start at 105. The slider goes up to 120, but that tends to make distant enemies hard to see.